Starfield:Vault Control Computer

Vault Control Computer

<Add description of terminal>

Menus

Vault Control Computer
Vault Status	VAULT STATUS WARNING!= CredTank Vault on FULL LOCKDOWN =WARNING! Command override from Captain Liang required to cancel this status. See documentation for details.
Cancel Lockdown	VAULT STATUS WARNING!= Lockdown Cancellation Not Available =WARNING! System is detecting severe internal damage to the connectivity of the security infrastructure. Lockdown reversal/cancellation is not possible at this time. Please report this to the maintenance technician immediately.
Vault Documentation	(Go to Vault Documentation menu.)
Vault Documentation
Emergency Procedures	Emergency Procedures 1. In the event of a security threat (i.e. any emergency which renders the cargo of the vessel at risk), a Lockdown Event will be automatically initiated. 2. During a Lockdown Event, all security bulkheads in the Engineering and Vault Section will seal, security doors leading into sensitive areas of the Vault will seal, security cameras throughout the ship will engage and all internal defenses (turrets and robots) will activate. 3. The lockdown can only be canceled using the Captain's Transfer Module in the Vault Control Room. 4. Please refer to your employee training guides on expected roles and behavior during a Lockdown Event.
Vault Credit Transfer	Vault Credit Transfer In order to properly offload the credits from internal CredTanks, please follow these instructions carefully. 1. The Captain and the authorized GalBank Representative at the drop-off point must be present in the Vault Control Room with properly-registered Transfer Modules. 2. Both parties will insert their Transfer Module into the Vault Control Console. 3. If a Data Storage Device is present, place it into the proper receptacle connected to the Vault Control Console. If mass offloading is being done into a certified GalBank Data Conduit, connect it at this time. 4. Activate the transfer. Please note that the transfer will require over seventy percent of the ship's power to accomplish (assuming a full CredTank load), so some ship-wide services may be interrupted at this time. 5. When the transfer is complete, remove the Transfer Modules and disconnect the Data Storage Device or GalBank Data Conduit.